Thanks for your effort to provide the patch. I’ve tried modprobe skge because it’s installed and I’ve tried to install sk98lin to vary degrees of failure. Tags for this Thread marvell 88e , skge sk98lin sky2 marvell. This problem caused serious unpredictable unstable behaviour in production servers stopping network traffic after a few days in November Graeme Hewson ghewson wrote on The original problem I reported is half-resolved with kernel 2. Chuck Short zulcss wrote on

Uploader: JoJokasa
Date Added: 26 May 2013
File Size: 47.76 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68785
Price: Free* [*Free Regsitration Required]

Would it be possible for you to test the latest upstream kernel?

Ethtool reports no link even though I am connected to my router. Introduction to Linux – A Hands mmarvell Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.

No problems occured during this test. Comment 47 Pete Philips Anybody got any answers? Link detection is still getting lost, but the dmesg output seems different: I had originally thought that Windows 7 somehow broke my nic because I temporarily loaded it on the box to update firmware on some of my other devices.

  GIGAWARE 10A09 DRIVER

CONFIG_SKY2: SysKonnect Yukon2 support (EXPERIMENTAL)

Comment on this change optional. The error is triggered when two machines are sending and receiving large amounts data over the bridge. Please test when it is available and let us know. Everything looks fine in Edgy. Comment 41 Neil Horman Please visit this page zky2 clear all LQ-related cookies.

drivers/net/ethernet/marvell/sky2.h – kernel/common – Git at Google

This has not been fixed in Dapper yet. I will be leaving this driver marvel, for my 2. Do you need to be fixed also in Breezy? Within 30 minutes tx timeouts will kill the network.

Here is a copy of the email that was sent out to address it: Link is up at Mbps, full duplex, flow control rx I’ve managed to replicate the error with a ping -f.

I am seeing the same thing marvvell my system with up to date Aye, right – turns out I did: The information about this bug in Launchpad is automatically pulled daily from the remote bug. I haven’t done a thorough speedtest and I don’t know how to look into error logs so I don’t know if any of this is really causing a problem.

  DELL 3100C VIDEO DRIVER

The 4 that are used use the sky2 driver. This was reset using the standard rmmod sky ; modprobe sky2 reset procedure.

You need to log in to change s,y2 bug’s status. Click Here to receive this Complete Guide absolutely free. After booting from Linux to Windows and from Linux to Linux, the interface works fine. Refused to change power state, currently in D3 [ If you need any further details of my setup, please just let me know.

The nic would not work after suspend on Windows 7 either even with the current Marvfll drivers from their site. I used the sk98lin driver with 9. It had been working for 7 years! Results 1 to 9 of 9.

Comment 32 Pete Philips I can however confirm that it remains a problem in RHEL5.